![]() ![]() Nothing I am aware of uses this, but it is possible and a wall wart using it would be useful as a part (I just haven’t gotten there yet.) In pcb If dimensions were in in or mm that wouldn’t matter, but in px it does (as well Fritzing guesses at the px value and often gets it wrong.) I also chose to add connectors for the barrel jack instead of only the terminals (and suppressed them in pcb view as not useful, which turned up a new Fritzing bug!) It is possible (I did it to see a couple of years ago) to make a barrel part that will “connect” in breadboard with a female barrel socket, thus the extra connectors. ![]() I would guess this was done in an earlier version of Inkscape such as 0.9.2.1 that is 90dpi/px where I am using 0.9.2.4 which is 96dpi/px. ![]() My new part on the left has the dimensions changed from px to in. Nice job in breadboard, but a few problems: dimensions are in px, which can cause scaling problems (and has here): ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |